HONEYWELL 80363972-150 DIGITAL INPUT MODULE BOARD

HONEYWELL 80363972-150 DIGITAL INPUT MODULE BOARD

Operator Controls

The monitor usually operates in the Operation mode, and the picture is aligned according to

the data in the internal memories that correspond to the video signal input.

Press the SELECT button, the monitor enters in the Adjustment mode, and the picture

becomes adjustable.

• MAIN SWITCH switch (see Figure 5-4)-

Turn on the power for the monitor by pressing the MAIN POWER switch to the

“ON” position (the “1” side of the switch) on the rear panel.-

To turn off the main power, press the MAIN POWER switch to the “OFF”

position (the “0” side of the switch).

IMPORTANT—If you do not use the monitor for a long time, please turn off MAIN

POWER switch on rear panel.

• FRONT POWER switch-

If you want the monitor in Off mode by FRONT POWER switch, while MAIN

POWER switch in on, press this switch button.  The POWER indicator will

turn to green.-

To change the monitor from Off mode to Operation mode, press the FRONT

POWER switch button or turn on/off the MAIN POWER switch.

NOTE: If the monitor is in Stand-by mode or Suspend mode, you can not operate the

monitor until the input signal status is returned to On Mode 1.  Please see next

item.

• POWER indicator

This monitor has power save mode, and POWER indicator lights as follows:

DEGAUSS button

The degauss function is automatically initiated when power is applied.  By pressing

the DEGAUSS button, the monitor will be manually degaussed.

NOTE: Manual degaussing is highly recommended after tilt and swivel operation.

POWER Indicator

DEGAUSS POWER

GREEN  ON  ORANGE:SAVE

DEGAUSS Button

FRONT POWER Switch

• CONTRAST control button

Refer to DISPLAY SETTING, subsection 5.4.3.3.

• BRIGHTNESS control button

Refer to DISPLAY SETTING, subsection 5.4.3.3.

53946

ADJUST

STORE

RECALL- +

ADJUST Button

STORE Button

RECALL Button

53942

• RECALL button

You can recall the factory adjusted data or initial default data (not user stored data)

by pressing the RECALL button more that two seconds.  After this, you press the

STORE button, the displayed data is stored in the memory.  If you want to recall

the user stored data, turn on/off the FRONT POWER switch

NOTE: If you press the RECALL button, and turn off the MAIN POWER switch

before pressing the STORE button and turn on the MAIN POWER switch

again, the screen displays the original stored data.

When the input signal is not a preset timing signal, if you press the STORE

button, all the LEDs light up indicating an error.

• STORE button

Press the STORE button after making the adjustments, the adjusted data is stored in

memory and the monitor exits from the Adjustment mode