KEBA KeDrive D3-DL 300 charging module
Product features
• Serial interface modules
(RS 232-C, RS 422/485-A, Current Loop)
• Full-duplex operation
• SSI interface module
• High interference immunity
• Electronic parameter chip
Short description
The SM 2×0/A series consists of serial and SSI interface modules that can be attached directly to a CPU module or
operated with all KEBA control systems by means of bus couplers.
SM 210/A and SM 230/A are serial interface modules and enable the connection of two RS 232-C or RS 422/485-A
serial interfaces. The two communication channels function independent of one another in full-duplex operation.
SM 220/A is a serial interface card. This module enables the connection of a serial 20 mA Current Loop interface. The
interface functions both for the transmitter as well as for the receiver in active or passive operation. DIP switches are
provided on the front for switching the operating mode. At a maximum transmission rate of 9.6 kbits/s, a line length of
up to 1.000 m is possible.
SM 250/A is an SSI interface module that enables the connection of up to 4 position measuring systems and is equipped
with sensor failure detection
Serial interface
SM 210/A SM 220/A SM 230/A SM 250/A
Number 2 1 2
Type of interface RS-232-C, 9-pin
Male connector
Current Loop, 9-pin Male
connector
RS-485-A / RS-422-A,
9-pin Male connector
(switchable via SW)
Data transmission rate 1200 to 115200 bits/s,
can be set via SW
1200 to 9600 bits/s,
can be set via SW
1200 to 115200 bits/s,
can be set via SW
Galvanic isolation No No No
Transmission medium Cable, shielded Cable, shielded Cable, shielded
SSI interface (only SM 250/A)
Number 4
Data transmission rate 125 kbit/s, 250 kbit/s, 500 kbit/s, 1 Mbit/s
Galvanic isolation No
Output voltage for encoder supply +24 V DC
Max. current for encoder supply 250 mA per channel
Sensor failure detection Yes
Dimensions, weight
SM 210/A SM 220/A SM 230/A SM 250/A
Height 120 mm
Width 22.5 mm front plate / 32.5 mm incl. K-bus plug
Depth 100 mm
Weight 132 g 132 g 132 g 140 g