MOOG D137-004-006 TFT Touch screen display

Cooling

Vents at the top and bottom of the G123-814 chassis provide cooling for internal electronic equipment. These vents should be kept clear.

It is important to ensure that the equipment below does not generate hot exhaust gases that could heat the G123-814.

Wiring

It is recommended that crimped “guide lace sleeves” be used as screw terminals.

Allow sufficient length of cable so that the wires remain connected when the circuit card is removed from the housing.

This allows the circuitry to be checked while the circuit card is still connected and operational.

For cables connected to the outside of the housing as well as for cables connected to the adjacent DIN rail unit, an additional 100 mm is sufficient.

The cable to the valve coil carries 1 Amp and should be sized accordingly.

Cables with a conductor size of 0.2 mm2 are normally rated at 1 Amp and are suitable for cable lengths up to 5 metres.

The recognised method is to use shielded cables for all connections, the

The accepted method is to use shielded cable for all connections and to radially

terminate the cable shield with a suitable grounded cable gland where it enters the industrial steel enclosure.

If this is not possible, chassis ground screw terminals are available on the G123-814.

The length of bare wire should be minimised. Connect the shield at each end of the cable to chassis ground.

This compact brushless Servo Motor is designed to meet the special requirements

of main battle tanks with 2-in-1 stator (double motor) arrangement to accommodate the high power needed.

The brushless servo motor is intended to be integrated into a traverse actuator with a gearbox,

brake and manual input/ auxiliary drive assembly.