OMRON F150-C10E-2 Vision Controller
OMRON F150-C10E-2 Vision Controller
Press the SHIFT+SET or SHIFT+RESET Keys to maintain the status of the
bit after the key is released. In this case, the force-set status is indicated by
an “S” and the force-reset status is indicated by an “R.”
To return the bit to its original status, press the NOT key or perform the Clear
Force Set/Reset operation. (Refer to 3-3-16 Clear Force Set/Reset for de
tails.) Forced status will also be cleared when the ID Controller’s operating
mode is changed (unless SR 25211 is ON, in which case forced status will
not be cleared when changing from PROGRAM to MONITOR mode) or
when operation stops as the result of an error or power interruption
Clear Force Set/Reset
This operation is used to restore the status of all bits which have been force
set or reset. It is possible in MONITOR or PROGRAM mode only.
RUN MONITOR PROGRAM
| PR6423/016-0300N021vibration pickup EPRO |
| PR6423/010-1300N021vibration pickup EPRO |
| PR6423/015-010ONO21vibration pickup EPRO |
| PR6423/11R-131+C0N031 vibration pickup EPRO |
| PR9268/301-100 vibration pickup EPRO |
| PR9268/302-100vibration pickup EPRO |
| E511A09X3N Eaton XT IEC contactor |
| PXle-5122779967-03 NI High-Speed Digitizer |
| 330101-00-14-90-02-008 3300 XL 11 mm Probe Bently Nevada |
| A6500-SR EMERSON A6500-SR System Rack |
| DC-TUIO31 HONEYWELL Universal Input Output IOTA 9 CC-TUIO41 Universal Input Output IOTA Red |
| PCI-6225 NI Multifunction DAQ |
| 1756-M08SE Allen-Bradley ControlLogix Serco Interface Module |
| FBM214B/216B RH924JH HART Communication Input Module FOXBORO |
| 1756-IB16S Allen Bradley ControlLogix 16-point Sinking Safety Input Modules |
1. Bring up the initial display.
2. Press the SET and then the RESET Key. A confirmation message will ap
Note If you mistakenly press the wrong key, press CLR and start again
from the beginning.
3. Press the NOT Key to clear the force-set/reset status of bits in all data areas.
Note Forced status will also be cleared when the ID Controller’s operating mode is
changed (unless SR 25211 is ON, in which case forced status will not be cleared
when changing from PROGRAM to MONITOR mode) or when operation stops
as the result of an error or power interruption.
3-3-17 Binary Monitor
1. 2. 3…
This operation is used to monitor the ON/OFF status of any word’s 16 bits. It
is possible in any mode.
RUN MONITOR PROGRAM
1. Monitor the status of the desired word according to the procedure described
in 3-3-12 Bit, Digit, Word Monitor. The desired word should be leftmost on
the display if 2 or more words are being monitored.
2. Press the SHIFT and then the MONTR Key to begin binary monitoring. The
ON/OFF status of the selected word’s 16 bits will be shown along the bottom
of the display. A 1 indicates a bit is on, and a 0 indicates it is off