HONEYWELL 51304690-100 DIGITAL INPUT CARD

AUTO SIZE/POSITION SET UP BUTTON (ON/OFF)-

AUTO

SIZE

Use to operate or cancel the automatic horizontal and vertical picture

sizing and centering function which recognizes the picture size and

position according to the signal applied to the monitor and adjusts

automatically.–

The indicator will be illuminated when the automatic function is on.

While the automatic function is on, it operates every time you turn the

power on or change the input signal.  It is best to keep the button off

when it is not necessary.

Note- When you operate the automatic function, you will need full

size picture information on the screen and the video input

signal with the maximum brightness such as Windows screen.

It may not operate properly with special picture information

such as only a prompt C> on the screen.-

When the picture adjusted by the automatic function needs to

be changed, operate the SIZE or POSITION BUTTON you

desire to change.

AUTO CONTRAST SET UP BUTTON (ON/OFF)

AUTO

CONT–

51304690-100

Use to operate or cancel the AUTO CONTRAST SENSOR.

The indicator will be illuminated when the sensor is in operation.

Note- When set to ON it will automatically adjust the crt contrast as

the ambient light of the room changes.

AUTO POWER-OFF SET UP BUTTON (ON/OFF)

AUTO

POWER–

Use to operate or cancel the AUTO POWER-OFF SENSOR.

The indicator will be illuminated when the sensor is in operation.

Note- When set to ON it will sense the presence of an operator in

front of the monitor.  It will automatically power down the

monitor when an operator is absent for more than an hour.

The power indicator will be green in a normal operation and

red when in stand-by-state.  To restore operation, either cycle

power or press the AUTO POWER button (cancels sensor).

RRC CONTROL BUTTONS-

Press to correct raster rotation or poor purity caused by magnetism when the

monitor is swiveled while in operation.-

When you press the RRC CONTROL BUTTONS at the same time for over

three seconds, you will hear a beep, and the adjusted condition will be canceled

and set back to the factory setting “center.”

Note:- The RRC CONTROL BUTTONS must be used after degauss has been

operated