AMAT 0190-24116 Analog I/O Plugin Module

AMAT 0190-24116 is a high-performance CDN396R Analog Input/Output (A-I/O) Plugin Board manufactured by MKS Instruments for Applied Materials.

This specialized PCB is an integral component of the Endura 2 and Centura 300mm semiconductor processing platforms,

facilitating the precise analog signal processing required for advanced thin-film deposition and etching.

Technical Parameter Table

Related Models

The 0190-24116 often works in tandem with other MKS-manufactured control boards within the AMAT electronics tower:

0190-04457 (CDN491): Digital I/O communication module.

0190-27072 (CDN491R): Revised digital interface card.

0190-08680: DeviceNet Scanner Card (3U CompactPCI).

0100-01944: Tower Interface (CCT) PCB for 300mm systems.

Application Cases

This board is primarily utilized in high-vacuum, high-precision environments:

PVD (Physical Vapor Deposition): Managing real-time feedback from DC/RF power supplies and magnetron controllers on Endura 2 systems.

Chamber Environment Monitoring: Converting analog signals from pressure transducers (Baratrons) and temperature sensors into digital data for the system controller.

Mass Flow Control (MFC) Interface: Orchestrating the precise analog voltage setpoints required for process gas delivery.

Product Advantages and Features

High Signal Integrity: Specifically shielded to operate in the high-EMF (Electromagnetic Field) environments typical of plasma processing chambers.

Endura 2 Optimization: Tailored specifically for the “Analog I/O Plugin” slots in the 300mm platform, ensuring plug-and-play compatibility without firmware conflicts.

Deterministic Performance: Provides low-latency data conversion, critical for maintaining process stability during rapid pulse-layer transitions.

Industrial Durability: Built with aerospace-grade components to survive 24/7 cleanroom operation cycles.

0190-24116

Installation and Maintenance

Installation: Ensure the system controller is powered down and standard ESD (Electrostatic Discharge) protocols are followed.

The card should be seated firmly into the plugin manifold; use the captive screws to ensure a solid ground path.

Calibration: After installation, a “Zero/Span” calibration via the AMAT service software is often required to synchronize the board with the specific transducers or power supplies it controls.

Maintenance: Visually inspect the gold-finger connectors for oxidation or debris.

In the event of a “Communication Timeout” or “Analog Drift” error, check the external DeviceNet cabling before replacing the board.

Unique Product Description

The AMAT 0190-24116 serves as the critical “translator” between the physical world of the process chamber and the digital logic of the tool controller.

By converting volatile analog voltages into actionable data, it allows the Endura 2 platform to maintain the extreme precision required for modern 300mm wafer fabrication.

It is a cornerstone component for fab engineers maintaining legacy and current-generation PVD fleets.