ABB Millmate Controller 400 PFXA401SF

PFXA401

Millmate Controller 400 has been designed to offer a lot of functionalities and at the same time a high degree of user-friendliness.

The control unit covers all edge sensor installation possibilities. This means the user only has to follow the step-by-step instructions in order to set up the control unit  and to have correct strip edge and center position and width calculated.

• Calculates true strip position and width in relation to the mill
• Filter times from 10 ms
• Easily configurable analog/digital inputs/outputs
• Digital edge position level detectors
• Digital min. and max. width level detectors
• Unit selection (mm, inch)
• Self-diagnostic test system including continuous edge sensor test
• Simulation mode for easy check of system integration
  

  Data

  External connections:

• 2 analog inputs for nominal thickness and nominal width setup
• 4 analog outputs, voltage or current
• 8 digital inputs for control signals
• 8 digital outputs
• +24 V supply for external units, max. 0.5 A
• Ethernet connection to:
  – other Millmate control and operator unit
  – other control systems with VIP protocol
• 2 serial interfaces of type RS-232 for external displays, control, etc.
• High-speed fieldbus (optional)

• 

  PFXA401

• EXTREME NETWORKS   BDX-MM1

  EXTREME NETWORKS BDXA-10G48T

  EXTREME NETWORKS BDXA-10G48X

  EXTREME NETWORKS BDXA-40G12X

  EXTREME NETWORKS BDXA-40G24X

  EXTREME NETWORKS BDXB-100G4X-XL

  EXTREME NETWORKS LPJ008A-T-R2

  Extreme Networks BlackDiamond8810

  ENTERASYS NETWORKS C5K17524

  Enterasys 6E123-50

  Enterasys 6E233-49

  Extreme Networks CFP2

  ENTERASYS NETWORKS S1300C-16ET2GF-APWR

  ENTERASYS NETWORKS X450-G2-24p-10